Philips 7FF1WD Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Cadres photo numériques Philips 7FF1WD. Philips 7FF1WD User's Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 1
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
Philips Photo Frame
Update Procedure Document
Reason for software update:
For 7FF1WD models
Software version A1.51 will provide the following improvements:
- Extend the SD card support from 1GB to 2GB
- Increasing maximum photos support number from 4096 to 10240
1. Check your current Photo Frame software version.
> Make sure Photo Frame is ON> Press the 3rd key from the left on the rear of Photo Frame >
General settings menu will appear. > Use the key behind the Down arrow to highlight Status. >
Current Software version will appear on the right column. > If the software version is earlier than
1.51, this update is applicable to your Photo Frame.
2. Prepare a supported memory card: If your software version is 1.47 or earlier than 1.31, only
Secure Digital (SD) type of memory card can be supported during software update. All other
versions support Secure Digital (SD), Memory Stick (MS), Compact Flash (CF), or Multimedia
Card (MMC) types of memory cards.
3. PC with Internet access or downloaded Photo Frame software on PC
Software update procedure
1. After downloading, Unzip all the software file, and select correct software update ZIP file
2. Unzip all the software update files (6 files in total) onto the root directory of the supported memory card
3. Make sure Photo Frame is OFF and properly connected to DC power.
Important: Please use DC power NOT battery power to avoid a possible power loss that could
cause permanent damage to your Photo Frame.
4. Insert the supported memory card into Photo Frame
5. Power on Photo Frame; the software update will start automatically. During the update, DO NOT
remove the memory card or make new connections.
Note: It may take up to 1 minute before the updating process begin. The screen will remain
black during this period
4. The Software update is complete when you see one of the following messages on Photo Frame:
Photos stored on your memory card
Or if you memory card does not contain photos:
No photos on external memory
6. After software update is complete, remove the memory card.
7. Restart Photo Frame
8. Congratulations! You have successfully updated your Photo Frame. You may remove the
software update files from the memory card now.
Troubleshooting:
In the event your software update is not successful, please make sure:
1. Your memory card is supported by current software
2. All files are correctly unzipped to the root directory of the supported memory card.
Note: If you have previously updated another Photo Frame with this memory card, some files may have
been changed by the update. Solution: Unzip the files again from the PC to the supported
memory card.
3. Make sure Photo Frame is properly powered during the entire update process.
Release date: Jul 13, 2006
Important notice before updating:
The software update process will remove all photos currently stored on Photo Frame. Please make
sure all photos on Photo Frame are properly
backed up before updating.
Firmware A1.51
What is needed before software update
WD_VA1.51_AllTypeCard.zipWD_VA1.51_SD.zip7FFEWD
Software version later that 1.31 but not 1.47Software version 1.47 or earlier than 1.31
Vue de la page 0
1

Résumé du contenu

Page 1 - Firmware A1.51

Philips Photo Frame Update Procedure Document Reason for software update: For 7FF1WD modelsSoftware version A1.51 will provide the following improveme

Commentaires sur ces manuels

Pas de commentaire