Philips LC5241 Manuel d'utilisateur

Philips Multimedia projector LC5241, LC5231User guideEnglishAuto imageInputStandby/On Status

Inserting the batteries in the remote control1.Press firmly and slide the battery cover off.2.Insert the two supplied batteries (sizeAAA1,5V/LR03). En

Video/computer cablesThese accessories (1 to 7) are supplied with the product forconnecting the projector to computer/AV equipment. The numbers in the

Connecting to a computerGeneral–This projector can be used as a display for numerousapplications by connecting the Data output connector of a PCto the

Connecting to video equipmentGeneral–You can connect up to two pieces of video equipment to theprojector following the illustrations below.–You can sw

COMPONENT VIDEO SIGNAL (YCbCr) 1.To use YCbCr component video input, set ‘SOURCECHANGE’ under ‘COLOR’ in the Advanced menu to ‘YCbCr’(see page 20).2.C

PreparationGeneral1.Press the Standby/On button to switch on the projector.– The Standby/On indicatorflashes green and the start upscreen appears for

8. Operation16Menu structure - data inputNote: The IMAGE and INFORMATION features are alsoaccessible in the Advanced menu. IMAGE COLOR VIEW SET UP OPT

Note: The IMAGE and INFORMATION features are alsoaccessible in the Advanced menu. 8. Operation17Menu structure - video inputIMAGE COLOR VIEW SET UP OP

GeneralThe projector’s picture is set to standard specifications at thefactory. However, you can adjust the image to suit your ownpreferences. The pro

DATA MODE - ADVANCED MENUPress the Menu button with the flip cover of the remote controlopen, to display the advanced menu. Use the cursor key(up/down

StatusStandby/OnInputAuto imageyIAuto imageInputStandby/OnOPENStatus2fig. 1fig. 20. Controls and connectionsAudio in Mouse Data / YCbCr Video inS-Vide

VIDEO/S-VIDEO MODE - ADVANCED MENUPress the Menu button with the flip cover of the remote controlopen, to display the advanced menu. Use the cursor ke

– PROJECTIONThe projector can be used in various positions with respectto the viewers and the projection screen. With thePROJECTION function via setup

Cleaning1.Press the Standby/On button to switch off the projector.– The standby indicator lights up red.2.Wait until the cooling fan has stopped (abou

Caution!– Do not use a lamp cartridge other than the Philipsreplacement lamp cartridge. Order this from your Philipsdealer using the unit model number

If a fault occurs, first check the points listed below before taking the projector for repair. If you are unable to remedya problem by following these

0. Controls and connections3fig. 3Mouse Standby /OnVideoMenuCancelDataAuto image D-Freeze A/V MuteD-Zoom VolumeD-KeystoneMouse Standby

Table of contents0. Controls and connections...21. Introduction...

Electrical energy can perform many useful functions. This projector has been engineered and manufactured to meetapplicable safety standards. IMPROPER

1. UGO X-lite Impact; LC5241Fully compatible with true XGA; support for SXGA usingadvanced intelligent compression technology. The advancedintelligent

Projectorfront (fig. 1)1 IndicatorsStandby / On (y |) indicator– Lights up orange in Standby mode– Flashes green when the lamp is starting up (1 min.)

The distance from the projector lens to the screen determines tothe size of the projected image, therefore, you need to considerthe place where you se

4.To switch off the mains supply completely, pull the mainsplug out of the wall socket.Note: Before disconnecting the power cord, make sure that theco