Philips 32PFL5614/60 Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
20
Reset the TV to factory
settings
You can restore the default picture and sound
settings of your TV. Channel installation settings
remain the same.
1 Press (Home).
2 Select [Setup] > [Installation] > [Factory
settings].
3 Press OK or to enter the [Factory
settings] menu.
» [Reset] is highlighted.
4 Press OK to reset to factory settings.
5 Press (Home) to exit.
Access decoder channel
You can map channels provided through a
decoder or descrambler to your TV channel
selection. In this way, you can select these
channels by using the RC of your TV. The
decoder or a descrambler must be connected
to EXT1.
Set decoder channel
Map channels from a decoder or descrambler
1 Press (Home).
2 Select [Setup] > [Installation] >
[Decoder].
3 Press to enter [Decoder].
4 Press to enter [Channel].
5 Press to select channel number to
map to the decoder/descrambler channel.
6 Press OK.
7 Press to select and enter [Status].
8 Press to select the connector used
by the decoder/descrambler ([None] or
[EXT 1]).
9 Press OK.
10 Press (Home) to exit.
Note
Select [None] if you do not want to map to
the decoder/descrambler channel.
Start a TV demo
1 Press DEMO on the remote control.
2 Press to select a demo and press OK
to view it.
3 Press DEMO to exit.
EN
Downloaded From TV-Manual.com Manuals
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

Commentaires sur ces manuels

Pas de commentaire