Philips HTB5150KD/98 Manuel d'utilisateur télécharger pdf (Page 34)

32 EN

Update software through

USB

What you need

• A USB ash drive that is FAT or NTFS-

formatted, with at least 256MB of memory.

Do not use a USB hard drive.

• A computer with Internet access.

• An archive utility that supports the ZIP le

format.

Step 1: Download the latest software

1 Connect a USB ash drive to your

computer.

2 In your web browser, go to

www.philips.com/support.

3 At the Philips Support website, nd your

product and locate the Software and

drivers.

» The software update is available as a

zip le.

4 Save the zip le in the root directory of

your USB ash drive.

5 Use the archive utility to extract the

software update le in the root directory.

» The les are extracted under the UPG

folder of your USB ash drive.

6 Disconnect the USB ash drive from your

computer.

Step 2: Update the software

Caution

• Do not switch off the home theater or remove the

USB ash drive during the update.

1 Connect the USB ash drive containing the

downloaded le to your home theater.

• Make sure that the disc compartment

is closed and no disc inside.

2 Press (Home).

3 Select [Setup], and then press OK.

4 Select [Advanced] > [Software update]

> [USB].

5 Follow the onscreen instructions to

conrm the update.

» Update process takes about 5 minutes

to complete.

» Once complete, the home theater

automatically switches off and restarts.

If it does not, disconnect the power

cord for a few seconds and then

reconnect it.

Update software through the

Internet

1 Connect your home theater to a home

network with a high-speed Internet access

(see 'Connect and set up a home network'

on page 13).

2 Press (Home).

3 Select [Setup], and then press OK.

4 Select [Advanced] > [Software update] >

[Network].

» If an upgrade media is detected, you

are prompted to start or cancel the

update.

» Downloading of the upgrading le may

take long, depending on your home

network condition.

5 Follow the onscreen instructions to

conrm the update.

» Update process takes about 5 minutes

to complete.

» Once complete, the home theater

automatically switches off and restarts.

If it does not, disconnect the power

cord for a few seconds and then

reconnect it.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 49 50

Commentaires sur ces manuels

Pas de commentaire