Philips V26CT Manuel d'utilisateur télécharger pdf (Page 118)

Changing Default Settings and Patient Category

3-44 Setting up your Monitor

Setting up your

Monitor

Changing Default Settings and Patient Category

Each system is configured in the factory with the factory default

settings. The settings are collected together to form Configuration

Sets. There are 4 Configuration Sets available with universal settings:

The Configuration Sets also include parameter default settings.

If your hospital requested it, these Configuration Sets will have been

customized at installation to your specific requirements. In this case

those new settings are the user default settings; if the settings were

not changed at installation, the user default settings and the factory

default settings are the same.

You can change the patient category within a Configuration Set during

normal monitoring. However, if after delivery of your system, you want

to change any of the other parameters or universal settings, you will

need to contact your Philips service engineer or your biomedical

engineering department, as this procedure has to be done in a special

Configuration Mode. Changes can be made to a Configuration Set to

suit an individual clinician's needs, for example, or to provide optimal

settings for a particular medical procedure.

Configuration Set 1 is for adult, intensive care unit application.

Configuration Set 2 is for adult, operating room application.

Configuration Set 3 is for neonatal, intensive care unit application.

Configuration Set 4 is for neonatal, operating room application.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 391 392

Pas de commentaire

Philips V26CT Manuel d'utilisateur Page 118